DALI Daylight Dimming / Daylight Harvesting

Energiesparendes Dimmen Flurbeleleuchtung Korridorbeleuchtung Lighting control via DALI often requires complex programming and commissioning. This doesn't have to be.

In an office building, a very convenient and energy-efficient DALI control system was implemented in the single and double offices with occupancy sensors and DALI lights.

DALI pendant lights with direct and indirect lighting are used.

Which functionality was implemented?

  • Presence notification: If an office is entered, the lighting is switched on or switched off again after leaving. 
  • Additional daylight control / constant light control: Since the offices have a lot of daylight, the lighting is automatically dimmed down continuously during the day as far as the incidence of daylight allows.
  • A specified light value (e.g. 500 lux) is always guaranteed as a minimum on the work surface (desk). The artificial lighting is only dimmed when the overall brightness is higher (artificial light + daylight).
  • The artificial light goes down to a maximum of 10%.

How was it realized? 

The DALI lights are controlled via an EPV DALI power pack. An ecos PM / 24V / 5LSa DIM occupancy sensor is directly connected to the power pack. In the larger offices, the monitoring area was expanded via plug & play with an ecos PM / 24V / 5 Slave sensor.

All ecos sensors are connected to each other via standard RJ12 cables and the corresponding accessories via plug & play.

All products used can be found at the bottom of this page.

For whom is it suitable?

This solution is suitable for:

  • offices 

Your advantage:

Commissioning takes place in seconds. No programming is required. The only settings (delay time and guaranteed light level) are made on the two potentiometers of the ecos occupancy sensor.

Filters
EPV
Power Pack DALI
DALI Power Pack supports all 24V occupancy sensors. Requires one x 24V-MASTER sensor. With plug & play up to 30 SLAVES sensors for coverage extension are supported. Supports up to 45 DALI devices. 125 DALI devices may be supported with addional DALI ...
* €72,90 * SRP
(€86,75 Incl. tax)
EPV
Occupancy Sensor ecos PM/24V/5LSa DIM MASTER
Combined occupancy and daylight harvesting sensor.
* €67,90 * SRP
(€80,80 Incl. tax)
EPV
RJ 12 Cable for MASTER/SLAVE connections.
6 meter, RJ12 Cable for connecting several 24V sensors together 1-to-1 straight through cable 6P6C. 100% electrically tested.
* €5,90 * SRP
(€7,02 Incl. tax)
EPV
2-into-1 RJ12 Adapters
Used for plugging several 24V sensors together (MASTER / SLAVE) Rule of thumb: Typically 1 unit per SLAVE sensor required.
* €5,90 * SRP
(€7,02 Incl. tax)
EPV
Extension occupancy sensor ecos PM/24V/5 SLAVE
SLAVE sensor for coverage area extension of all EPV MASTER sensors. In two variations available. Up to 12 meter installation height.
* €40,90 * SRP
(€48,67 Incl. tax)