The first occy product version is occy smarthome (24V). This sensor consists of the sensor head - with all accessories for the 4 installation types - and a small powerpack for the connection to your control system.
This makes it the ideal signal transmitter for your smart home projects, e.g. with Loxone, Homematic, Comexio, WAGO and similar systems. With occy you realize reliable motion sensing and lighting control in discerning applications - and still meet the highest design requirements.
Instruction manual / data sheet
occy smarthome puts out:
- the occupancy / motion signal as a high/low level output (transistor output in push-pull mode) with a delay time of approx. 10 seconds. You can use this to connect to a binary input on your control system.
- the measures light level in the room as a 1-10V signal, active or passive: 0 Lux = 0V, 1.000 Lux = 10V.
- Max. load for both outputs (active & passive): 10mA
- For most control systems (e.g. Loxone) no pull-up Resistor is required
- Powerpack connections: screw terminals
- solid wire: up to 1,5 mm2
- flex wire: up to 1 mm2
Expanding the coverage (Master / Slave)
To one Powerpack you can connect up to 5 additional powerpacks (and sensors) as Slaves. This is done with any simple 2-core cabling. In this way you can increase the coverage area without using additonal inputs on your control system.
The connected sensors will work in parallel, i.e. like one sensor with a very large observation area. Every powerpack offers a 4-pole terminal for Slave extensions so that you can easily daisy-chain the additional units.
Commissioning & Test Mode
Following the connection of the power supply to the powerpack or a (re-)connection between the sensor head and powerpack, the sensor will automatically go into commissioning mode: For 5 minutes the head will flash green whenever motion is detected. After these 5 minutes the green LED will remain off. In normal operation the sensor does not optical signal and is acoustically completely silent.
Distance between sensor head and powerpack: 30 meters are fine.
If required the distance between sensor head and powerpack can be increased. You can expand this distance with 4-core wire, 3,5mm plug/socket) for up 30 meters. This is a plug & play solution with the 7-meter extension cables you can find in our shop.
What do our customers say?
Here is an example of how to connect occy to a control unit (Loxone):