Wiring diagram:

Loxone Miniserver

Connect the motion signal to the digital input:

Connect the motion signal of the sensor (BM) with one of the digital inputs I1 to I8.
The output of the occupancy sensor is designed as a push-pull.

Connect brightness value to the analog input:

Connect the light value signal of the sensor (1-10V) to one of the analog inputs AI1 to AI4.
The occupancy sensor displays the light value as a 1-10V analog value. With more light in the room, the voltage increase. (0V = 0 lux, 10V = approx. 1000 lux).

Terminal pin assignment of the occupancy sensor:

terminal pin assignment of the presence detector description value
24V supply voltage 15 – 28 V DC
GND ground / GND 0V
BM motion detected movement = approx. supply voltage
no movement = 0V
max. 10 mA active/passive
1-10V brightness 1-10V (0V = ca. 0 Lux, 10V = ca. 1000 Lux), (max. 10 mA)
SLAVE + SLAVE-extension Two-wire line
SLAVE - SLAVE-extension

Pin connection Loxone Miniserver:

I1 – I8 Digital inputs Internal input resistance: 10kOhm
Max. 100 mA
• 0-7.2 V corresponds logically „0“
• 7.0-8.2 V = switching threshold bzw.
AI1 – AI4 Analog inputs 0-10V DC, resolution10 Bit,  internal input resistance
10kOhm
Also usable as digital input (24VDC)
• < 1V corresponds logically „0“
• 1 - 24V corresponds logically „1“
Q1 – Q8 Analog inputs
(Relais)
250 V AC 5A at cos phi =1,
30 V DC 5A
(With higher loads an auxiliary relay must be used)
AQ1 – AQ4 Analog outputs 0-10V DC, resolution 12 Bit, max. 20mA output load