occy supplies you with two signals:
- the motion signal as a high / low level output (100% silent, non-audible transistor output in push-pull setup) with a delay time of approx. 10 seconds. Motion = High. No motion = Low. You can connect this output to the binary input of your control system.
- the measured overall room brightness (lux-level) as a 1-10V Signal, usable actively or passively: 0 Lux = 0V, 1.000 Lux = 10V.
Max. load on both signals (active & passive): 10mA.
For the connection to most control systems (e.g. Loxone) no pull-up resistor is required. Connections on powerpack: screw terminals (flex: up to 1.5mm2 / flex: up to 1 mm2
Commissioning & Test Mode
After you connect the supply oltage the sensor goes into a test mode. For 5 Minuten the green LED lights up whenever motion is detected.
After that, the LED remains off. During normal operation, the sensor does not create any visual or acoustic signal / noise.
Distance between sensor head and powerpack: up to 30 meters
If required, the power pack can be located far away from the sensor head. For this purpose you can extend the connection between sensor and powerpack (4 core jack/socket cable 3.5mm) up to 30 meters. This is possible in a very simple plug & play fashion with our 7-meter extension cables.